BHDMM - ENAMEL GLOSS 13538, YELLOW
- MSDS: BHDMM
- Manufacturer: CON LUX COATINGS INC
- Product Name: ENAMEL GLOSS 13538, YELLOW
- National Stock Number: 8010-00-527-2045
Product Identification
Product ID:ENAMEL GLOSS 13538, YELLOW
MSDS Date:09/26/1984
FSC:8010
NIIN:00-527-2045
MSDS Number: BHDMM
Responsible Party
EDISON, NJ 08818-0847
US
Emergency Phone: (206) 287-4000
Info Phone: (206) 287-4000
Cage: 60189
Contractor
Telephone: 732-287-4000
Cage: 60189
Ingredients
NAPHTHA (PETROLEUM SPIRITS OR BENZIN)
CAS: 8030-30-6
RTECS: SE7555000
Fraction By Weight: 38.2%
OSHA PEL 100 PPM
LEAD CHROMATE
CAS: 1344-37-2
Fraction By Weight: 27%
OSHA PEL 0.05 MG/M3 (PB)
ACGIH TLV: 0.05MG/M3(CR)A2;8990
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Effects of Overexposure:EYE/SKIN: IRRITATION MAY OCCUR WITH
OVEREXPOSURE. INHALATION: CONTINUED
BREATHING OF VAPORS, IN SOME INSTANCES, MAY IRRITATE
RESPIRATORY TRACT AND CAUSE HEADACHE OR DIZZINESS, WHICH IS NORMAL
FOR SOLVENTBASE PRODUCTS.
First Aid
First Aid:SKIN/EYE: FLUSH WITH PLENTY OF WATER.
INHALATION: REMOVE TO FRESH AIR. IF IRRITATION
PERSISTS, CONSULT A PHYSICIAN.
Fire Fighting
Flash Point Method:TCC
Flash Point:105F/40.56C
Upper Limits:1.0
Extinguishing Media:FOAM, CO2, DRY CHEMICAL, WATER MIST
Fire Fighting Procedures:SMOTHER FLAMES WITH ONE OF THE ABOVE
EXTINGUISHING MEDIA. WATER MAY BE USED TO COOL DOWN UNOPENED
CONTAINERS IN VICINITY.
Unusual Fire/Explosion Hazard:CONTAINS FLAMMABLE SOLVENT. DO NOT USE IN
AREAS WHERE SPARKS OR OPEN FLAMES ARE PRESENT.
Accidental Release
Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. AVOID
PROLONGED BREATHING OF VAPORS. VENTILATE AREA. CLEAN UP
WITHABSORBENT MATERIAL.
Handling
Handling and Storage Precautions:STORE IN BUILDINGS DESIGNED AND
PROTECTED FOR STORAGE OF NFPA CLASS II FLAMMABLE LIQUIDS.
Other Precautions:STORE IN BUILDINGS DESIGNED AND PROTECTED FOR STORAGE
OF NFPA CLASS II FLAMMABLELIQUIDS.
Exposure Controls
Respiratory Protection:IN OUTDOOR/OPEN AREAS USE APPROVED FILTER
RESPIRATOR. IN RESTRICTED VENTILATION AREAS USE APPROVED CHEMICAL
FILTERS.
Ventilation:GENERAL OR LOCAL EXHAUST VENTILATION IN VOLUME AND PATTERN
TO KEEP TLV BELOW LIMIT.
Protective Gloves:REQUIRED FOR LONG EXPOSURE
Eye Protection:SAFETY GLASSES
Other Protective Equipment:PREVENT PROLONGED SKIN CONTACT
W/CONTAMINATED CLOTHING.
Supplemental Safety and Health
NK
Chemical Properties
Boiling Pt:B.P. Text:315-380F
Vapor Density:> AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:60
Stability
Stability Indicator/Materials to Avoid:YES
NK
Hazardous Decomposition Products:CO, CO2
Disposal
Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE,
AND LOCAL REGULATIONS. DO NOT INCINERATE UNOPENED CONTAINERS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.